Boles Expert Flooring
Seamless flake floor running along kennel runs

Tile overlay system

A new seamless floor right over your existing tile.

  • No tile tear-out
  • Grout lines won't show
  • Resists cracking

Tearing out tile is expensive, slow and messy. With our tile overlay system, we coat directly over well-bonded tile. The first coat fills the grout lines so they don't show through, and a flexible urethane layer resists cracking. It's a common choice for commercial kitchens, hospitals and schools.

What it does

No tile tear-out

Skip the cost, time and mess of removing the old tile.

Grout lines won't show

The first coat fills the grout lines and skims the tile, so the lines don't ghost through the finished floor.

Resists cracking

A flexible urethane layer gives the floor crack isolation.

Moisture protection

The first coat is also a moisture vapor barrier that meets the ASTM F3010 standard, which protects the floor from moisture coming up from below.

Walls too

Tile walls and wainscots can be coated the same way.

Low-odor finish option

A matte, water-based finish coat with no odor is available, which helps in occupied buildings.

Integral cove base option

The coating can run up the wall as a built-in cove base, so there's no seam where the floor meets the wall.

Slip resistance tested

With a sand-and-flake texture, the topcoat tested at a 0.96 coefficient of friction.

Chemical resistant

Once fully cured (7 days), the topcoat is rated for 7 days of contact with fuels, oils, solvents, acids, caustics and cleaners.

How it's built

A seamless, textured flake finish with no grout lines showing.

  1. Topcoat
  2. Optional second broadcast
  3. Flexible urethane and flake
  4. Grout-filling moisture barrier
  5. Tile preparation
  6. Concrete slab
  1. 01

    Tile preparation

    The tile and grout are cleaned with a pH-neutral cleaner and left to dry. Loose or missing tiles are patched.

  2. 02

    Grout-filling moisture barrier

    A sand-filled moisture barrier is troweled on to fill the grout lines and skim the tile.

  3. 03

    Flexible urethane and flake

    A urethane coat is troweled on and back-rolled, and flake is broadcast into it while it's wet.

  4. 04

    Optional second broadcast

    A clear coat gets another full broadcast of flake.

  5. 05

    Topcoat

    A 100% solids polyurethane topcoat. A matte, no-odor finish coat can go on top.

At a glance

Best for
Replacing a tile floor without tear-out
Look
Flake, textured
Goes over
Existing well-bonded tile
Main coating
Epoxy moisture barrier plus flexible urethane
Flexible base (bridges minor cracks)
Yes
Moisture vapor barrier
Included
Topcoat and sheen
Polyurethane, matte option
Surface
Textured
Back in use
Walk in 24 hrs, drive in 72 hrs
See how it compares with our other floors

Good to know

  • Foot traffic after 24 hours, vehicles after 72 hours.
  • The tile has to be well bonded. Loose or missing tiles are patched first.
  • Full chemical resistance once the floor has cured for 7 days.

Options

  • Flake color blends
  • Second broadcast
  • Coating tile walls
  • Matte, no-odor finish coat
  • Integral cove base
Finished, gleaming commercial floor

Get a quote for tile overlay system

Professionally installed by licensed, insured crews and backed by a lifetime installation warranty.